The Gremlin
#76
CF Veteran
Join Date: Oct 2012
Location: Capac, Mi
Posts: 1,127
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0L
yep i did, now i cant get the truck to run correctly after rebuilding the carb. i may admit defeat and order the quick efi setup from summit. i can get it to run and rev but wont idle at all. its been way too long since i have dealt with carbs.
#79
CF Veteran
Thread Starter
Join Date: Sep 2013
Location: California
Posts: 1,552
Likes: 0
Received 7 Likes
on
7 Posts
Year: 91
Model: Cherokee
Engine: 4.0
I got an old Holly I had on a 390 laying around. If I remember correctly it's a 3310 or maybe an 1850. I have no use for it. Pay for the shipping and it's yours.
#81
CF Veteran
Thread Starter
Join Date: Sep 2013
Location: California
Posts: 1,552
Likes: 0
Received 7 Likes
on
7 Posts
Year: 91
Model: Cherokee
Engine: 4.0
Not this weekend but next I can. It's in the garage that the Gremlin is at and I have to go shopping for a new living room set this weekend. There is a small possibility that I might get an itch on Sunday to go there and start putting the motor back together. Either way I will get you a price. You would think that it wouldn't cost more then $20 maybe $25 though. Just so there is no surprises I can get you some pics and it's been sitting for about a decade. Ran great when pulled but you should do a rebuild.
#83
CF Veteran
Thread Starter
Join Date: Sep 2013
Location: California
Posts: 1,552
Likes: 0
Received 7 Likes
on
7 Posts
Year: 91
Model: Cherokee
Engine: 4.0
I've ran Quadrajets most of my life. Dam good carb. I keep a rebuilt spare in the trunk of the caddy and a box of jets and metering rods. Don't ever really need it but that car can go from DD to sitting indefinitely.
Last edited by bubbarules1958; 09-28-2016 at 08:11 PM.
#85
CF Veteran
Join Date: Oct 2012
Location: Capac, Mi
Posts: 1,127
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0L
there is 3 vac lines on my engine(PVC,Vac advance,brake booster) all have been replaced when i got the truck, floats were set with a 7/16s drill bit, and the little ruler i got with the rebuild kit. im leaning more towards i have the idle screws too far in. or i didnt get the passageways clean enough when i soaked it.
Bubba, that sounds fine, im in no hurry. the truck will be going into winter storage here in a few weeks, since it got really cold and wet really quick.
Bubba, that sounds fine, im in no hurry. the truck will be going into winter storage here in a few weeks, since it got really cold and wet really quick.
#86
CF Veteran
Thread Starter
Join Date: Sep 2013
Location: California
Posts: 1,552
Likes: 0
Received 7 Likes
on
7 Posts
Year: 91
Model: Cherokee
Engine: 4.0
Got the bottom half of the engine almost put back together. Just need to rent a harmonic balancer install tool. Not ready to get it back in yet. Thinking about cutting up the firewall, engine cross member and moving the engine around a little bit.
Started to clean up the interior. Removing all the rubber coating, useless sheet metal tabs and stuff.
Got the new steering wheel in. Went with a theft device in case I have to carport it. My insurance company put one in my Nova right after Grant came out with them. Thinking about putting on on my XJ.
Found this when I was finishing up. More work....
Last edited by bubbarules1958; 10-10-2016 at 06:13 PM.
#87
CF Veteran
Join Date: Oct 2012
Location: Capac, Mi
Posts: 1,127
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0L
Nice, i had one of their security systems on my Chevelle and my S10 when i lived in San Diego, granted we were on the Naval base but still. Insurance wanted to make sure neither could be stolen.
#89
CF Veteran
Join Date: Oct 2012
Location: Capac, Mi
Posts: 1,127
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0L