Dropped tool while changing ignition coil
#1
Newbie
Thread Starter
Join Date: Oct 2014
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Dropped tool while changing ignition coil
While changing spark plugs in my 2003 Jeep Grand Cherokee, dropped a tool that I cannot see to recover into hole near where the ignition coil slides over the spark plug. It starts fine but I am worried that it may rattle around and cause some damage to the engine. Any suggestions on how to recover and is it safe to drive? Any help is greatly appreciated.
#3
Newbie
Thread Starter
Join Date: Oct 2014
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
I dropped a ratchet wrench extension on the passenger side of the engine near the 4th coil (located under the oil and trans dip sticks). I do not have a picture but the jeep runs fine.
#5
Old fart with a wrench
I'll bet you're talking about the spark plug tubes on the 4.7, ain't ya? They lead into the valve and cam area and could cause some problems. If it were mine, I'd take the cam cover off and find it.
Thread
Thread Starter
Forum
Replies
Last Post
Blackcherokee290
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
27
07-26-2022 07:52 PM
rdr8887
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
33
08-08-2017 07:28 AM
Jose Calderon
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
17
09-17-2015 08:57 PM
Gauge
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
08-27-2015 08:43 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)