luciejbrown

motor turns over but wont start,,,, when u turn key on if the check engine light does happen to turn on then the jeep will start and runs good but if check engine dont turn on jeep will not start it might be a week before it starts again... changed fuel pump relays fuses,going to look at the steering column and ignition switch but it seems like it loses ground some where or broken wire, any ideas come say computer board some say not???

Bustedback

Check out the long flat plug at the bottom of the ignition switch for a bad connection.

draphty

Check all connections going to the computer. My '95 wouldn't start...turned over fine, no cel on ignition. It was the computer. Hope this helps.

Draphty