Will's 1 ton Cherocar
#1533
MJ>XJ
Join Date: Mar 2009
Location: Griffin, G.A.
Posts: 17,836
Likes: 0
Received 4 Likes
on
3 Posts
Year: 1990
Model: Comanche
Engine: 4.0 I6
Thats what i have and on my 90 its by no means a bolt in... lines are even wrong thread... had to put new ends on my lines to match up and fab up a new little rod thing... wasnt hard but not a bolt in...
#1534
I would like to see a pic of your passanger side knuckle that you made double shear with the tierod and drag link connected. Also how wide is the frame side track bar bracket inside?
#1537
CF Veteran
Thread Starter
Join Date: Apr 2011
Location: Carrollton, GA
Posts: 14,553
Likes: 0
Received 1 Like
on
1 Post
Year: 1994
Model: Cherokee
Engine: Inline 6 4.0L High Output
Been trying to wheel when I can lately. Haven't posted much here because I can only do one picture per post on my phone before it locks up.
Wrapping up my cage project
Tied in with 4" 3/16 plates and 3/4" angle iron
Need to pull my seats real quick and weld the kickers to the inside B pillar, put the front fenders back on, and reinstall my gas tank until I get my fuel cell in and the hole patched. I'm pretty happy with how it came out other than the lack of C pillar tie ins right now, I should have ran the D pillars down into the hole where I chopped it, and there is a wave in the roof now for some reason.
Wrapping up my cage project
Tied in with 4" 3/16 plates and 3/4" angle iron
Need to pull my seats real quick and weld the kickers to the inside B pillar, put the front fenders back on, and reinstall my gas tank until I get my fuel cell in and the hole patched. I'm pretty happy with how it came out other than the lack of C pillar tie ins right now, I should have ran the D pillars down into the hole where I chopped it, and there is a wave in the roof now for some reason.