The Baconator
#76
Member
Thread Starter
Join Date: Jun 2012
Location: Missouri
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L I6 MPI "Power Tech HO" (High Output)
Freezing for a Reason
Top Off. Top Down. Annual Ride for Special Olympics Missouri
#81
Member
Thread Starter
Join Date: Jun 2012
Location: Missouri
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L I6 MPI "Power Tech HO" (High Output)
#82
Member
Thread Starter
Join Date: Jun 2012
Location: Missouri
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L I6 MPI "Power Tech HO" (High Output)
Cheap Hood Vent
Laugh if you must but these babies work great while i'm offroading. I never get hot now or even come close to overheating, they were free and I can close them if needed!
#87
Member
Thread Starter
Join Date: Jun 2012
Location: Missouri
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L I6 MPI "Power Tech HO" (High Output)
A few things done from last week
Went to a product demo for Sprintex Superchargers and drove a 2014 JK 2-door with Supercharger.....It was really fun and had alot of power! Great on the highway!
Then went for a walk with the wife, kiddo, and dogs and decided to snap a pic of baconator
Later that night i tested and positioned the new headlights and LED bar
Then this weekend i needed to change the upper and lower balljoints so i started....then while removing lower ball joint on passenger side using a breaker bar and 4 foot cheater....I snapped my friends ball joint press (damn cheap Harbor Fright tool)
I'll snap more pics of me finishing up ball joint using my friends Snap On Ball Joint Press this week.
Then went for a walk with the wife, kiddo, and dogs and decided to snap a pic of baconator
Later that night i tested and positioned the new headlights and LED bar
Then this weekend i needed to change the upper and lower balljoints so i started....then while removing lower ball joint on passenger side using a breaker bar and 4 foot cheater....I snapped my friends ball joint press (damn cheap Harbor Fright tool)
I'll snap more pics of me finishing up ball joint using my friends Snap On Ball Joint Press this week.
#88
CF Veteran
I did my ball joints with one of those cheap presses.....never again. I bent the lower half almost 45 degrees and made it a hell to align everything.
#90
Member
Thread Starter
Join Date: Jun 2012
Location: Missouri
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L I6 MPI "Power Tech HO" (High Output)
So was pushing hard to finish the front end work before the KC Northland Jeepers Drive In invasion to see Furious 7 but didn't get to. Took these photos.