Need some help with wiring driving lights.
#1
Junior Member
Thread Starter
Join Date: Nov 2011
Location: Wernersville, PA
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0 I6
Need some help with wiring driving lights.
Sorry to start another thread about this but haven't found one that had what I was looking for. So here we go.
I have a 99 classic that has the pigtail for the fog lights, but that's it, no wiring in the engine compartment and nothing in the fuse/relay compartment in the engine bay. I want to use the factory switch, which I bought and have the correct bezel. I want to wire them up like they were factory meaning that they turn off when the high beams are activated. I just for the life of me figure it out. Please HELP!!!
I have a 99 classic that has the pigtail for the fog lights, but that's it, no wiring in the engine compartment and nothing in the fuse/relay compartment in the engine bay. I want to use the factory switch, which I bought and have the correct bezel. I want to wire them up like they were factory meaning that they turn off when the high beams are activated. I just for the life of me figure it out. Please HELP!!!
#2
CF Veteran
Join Date: Feb 2010
Location: Oroville, CA
Posts: 12,367
Likes: 0
Received 19 Likes
on
18 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0 with all of the noise and clatter
I'm in the same boat with my ZJ. I left the boneyard today all fat dumb and happy with a fog light harness, headlamp switch, brackets, and some other stuff, only to find out the PDC is not even wired for the fog light relay or fuse. Pisser.
#5
CF Veteran
Join Date: Apr 2012
Location: Wisconsin
Posts: 5,302
Likes: 0
Received 19 Likes
on
16 Posts
Model: Cherokee
Here's the '99 factory wiring:
The fog lamp control relay grounds through the high side of the high beam bulb. When the high beams are off, the relay can operate, grounding through the bulb filament. With high beams on the fog relay is disabled since +12V is applied to both sides of the coil.
The fog lamp control relay grounds through the high side of the high beam bulb. When the high beams are off, the relay can operate, grounding through the bulb filament. With high beams on the fog relay is disabled since +12V is applied to both sides of the coil.
Last edited by Radi; 11-04-2012 at 01:48 AM.
Thread
Thread Starter
Forum
Replies
Last Post
BayArea93xj
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
06-11-2016 10:43 AM
rusty_bucket
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
08-29-2015 06:42 AM
Waynerd
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
08-25-2015 11:34 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)