got2bamber

I just bought a 98 jeep cherokee classic. It stumbles at high rpms and I've tried fixing everything on it. I've tried injectors, fuel line, fuel pump, throttle body, iac, distributor, new plugs and wires, new rotor. I need help! I cant figure out what else to do. Ive tried everything and I cant keep putting money into it without solving my problem. SOMEONE PLEASE HELP ME!could this be a transmission issue?

freegdr

Step 1.Check codes .....

got2bamber

already done that says crankshaft sensor and 02 sensor but neither of them was the problem

freegdr

Did ya clear them then drive and recheck b4 buying parts ?

ZombieResponseJeep

When my '98 did this it turned out to be a plugged converter.

PuertorricanXJ

where did you buy the cps from ? is it replacement or oem ??

tjwalker

This is where a "scan tool" would be the ticket. Hook it up and drive it and then look at all of the specific systems when you see symptoms and see if you can find which one is out of spec and may be the culprit.

If you don't have a scan tool, it would be worth it to pay a shop to do this for you. Much cheaper and effective than throwing any more parts at it.

Also please post the EXACT crank sensor and oxygen sensor codes. They may be related. You should chase and resolve every code.

got2bamber

It is throwing about 12 codes. I took it to AZ to check them. was going to right them down but guy was rude. But its throwing codes for loss of cps, injector 6, throttle position sensor, iac, 02 sensor, iac . can't remember the rest of them but the guy said it could be one thing causing all of them?
It was a oem that we switched it with . and i have no converter, it was gone when i bought the jeep. Someone told me it could be a dropped valve, so just got done taking the valve cover off, and they are all fine. running out of options :/ could this be an ecu problem? i reset the ecu yesterday, cel went off for a bit but had the same stumbling problem, then light came back on :/

PuertorricanXJ

Could be the camshaft position sensor or that the crankshaft position sensor you got was faulty

got2bamber

it was doing this before i replaced the sensor

PuertorricanXJ

.

PuertorricanXJ

Mine was doing the same until i got the oem cps , the oem oxygen sensors and the oem ignition coil i also cleaned the injector with fuel injector cleaner and the throttle body could also be a vacuum seal problem

got2bamber

well all the backfiring and skipping and popping caused my transmission to go out. now its in the shop ; mechanic is gonna fix the problem too with another sensor and adjusting the distributor ? we just replaced the distributor but... i guess he knows more than we do! ill let ya know what happens.

knever3

Your distributor is off one tooth, I had the same problem after replacing a bad dist gasket. Ease on the gas and it's fine, get in the throttle and it spits and sputters and backfires. Just pull the cap off, rotate the crank to #1TDC and see if the pointer is at or just before the number 1 cylinder. Pull the dist, index one tooth and reinstall. Double check where the pointer is again.