rear wiper motor relay clicking but not turning
#1
Member
Thread Starter
Join Date: May 2009
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L
rear wiper motor relay clicking but not turning
I just bought a used motor off ebay and when I installed it yesterday I couldn't get it to work. When the wiper switch is on I can hear the relay clicking which I assume means the motor/shaft should be turning but it's not. Took the cover off the old motor and played around with that one some and noticed it was binding up, but when I plug it in I get the same type of clicking. Are they both bad or could it be something else?
#2
Senior Member
Join Date: Apr 2009
Location: Grand Haven, Michigan
Posts: 922
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1998, 1999
Model: Cherokee
Engine: 4.0
I just bought a used motor off ebay and when I installed it yesterday I couldn't get it to work. When the wiper switch is on I can hear the relay clicking which I assume means the motor/shaft should be turning but it's not. Took the cover off the old motor and played around with that one some and noticed it was binding up, but when I plug it in I get the same type of clicking. Are they both bad or could it be something else?
#3
Member
Thread Starter
Join Date: May 2009
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L
Should the output shaft spin freely? MY old assembly was missing the shaft and wiper arm. I hit the new one with some pb but it doesn't really spin at all even without the arm
Thread
Thread Starter
Forum
Replies
Last Post
seansr
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
12
11-15-2022 06:08 AM
jghaenlein
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
8
08-27-2015 07:07 AM
03cheroke
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
08-27-2015 06:07 AM
relcock
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
08-26-2015 11:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)