Engine cuts out while driving.
#1
Newbie
Thread Starter
Join Date: Oct 2010
Location: Jasper, IN
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0L
Engine cuts out while driving.
Recently the engine on my 2000 sport 4.0 has been shutting off while driving down the road. All of the electronics stay on and the first few times it started right back up. The last few times it happened it wouldn't start right away but after about 5-10 min it would start right up again. I've only been driving it back and forth to school and it seems to happen about 4 miles out from wherever I start from, once the engine is warm. There's no check engine light that comes on. Its not happening when I pull up to stop signs or light so I don't think it is the IAC. I'm not too experienced with working on my own stuff since I've been learning on my Jeep, which is my first vehicle. I have done a few thing on it so I'm not mechanically incompetent but I don't know where to start with this one. Any help is greatly appreciated.
#2
Junior Member
Join Date: Sep 2011
Location: Macomb,MI
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
I had the same problem after I changed my oil, filter, sparkplugs and cleaned everything down there. The engine would turn off and everything else would stay on while driving.
Found out the oil pressure sending unit casing cracked and opened up causing the three little wires inside to touch each other and kill the engine. With the engine running, reach down and wiggle the sending unit casing and see if the motor dies.
I was completely suprised that a little sending unit could be a kill switch.
Found out the oil pressure sending unit casing cracked and opened up causing the three little wires inside to touch each other and kill the engine. With the engine running, reach down and wiggle the sending unit casing and see if the motor dies.
I was completely suprised that a little sending unit could be a kill switch.
#4
CF Veteran
Join Date: Nov 2010
Location: In the middle of Minnesota!
Posts: 5,804
Received 99 Likes
on
88 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
The most common cause of the engine intermittently shutting off on the Jeep 4.0 engine is a failing "crankshaft position sensor".
They can be tested, but testing of something that is intermittent often is of little value. Often they will fail without setting a check engine light or a code.
If you buy one, do yourself a favor and buy a Mopar unit directly from the Jeep dealer for best reliability and longevity. No lack of threads of issues with aftermarket crank sensors.
They can be tested, but testing of something that is intermittent often is of little value. Often they will fail without setting a check engine light or a code.
If you buy one, do yourself a favor and buy a Mopar unit directly from the Jeep dealer for best reliability and longevity. No lack of threads of issues with aftermarket crank sensors.
#5
CF Veteran
I will triple the vote for CPS (Crank Position Sensor) and will reiterate tj's recommendation that you avoid the Chinese made Duralast CPS available at Awful Zone. I know there's a fairly reliable testing procedure for RENIX era CPSs but I'm not sure about later models.
For the record, my agreement with tj regarding imported CPSs is based solely on what I've read, not personal experience. I installed a Duralast in mine a few months ago and have had ZERO problems with it, so far. I think it was $28, which is between 1/2 and 1/4 of what I've seen paid for an OEM unit. I've heard of the Duralasts failing out of the box, though so I probably just got lucky and since they're kind of a pain to replace, it's best to only have to do it once.
For the record, my agreement with tj regarding imported CPSs is based solely on what I've read, not personal experience. I installed a Duralast in mine a few months ago and have had ZERO problems with it, so far. I think it was $28, which is between 1/2 and 1/4 of what I've seen paid for an OEM unit. I've heard of the Duralasts failing out of the box, though so I probably just got lucky and since they're kind of a pain to replace, it's best to only have to do it once.
#6
Newbie
Thread Starter
Join Date: Oct 2010
Location: Jasper, IN
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0L
Thanks for all the help. My dad has a buddy who works at the Jeep dealership in town so I'm having him take a look at it and hopefully if that's the case then he will be able to get me one for a bit cheaper than usual.
#7
CF Veteran
Join Date: Nov 2010
Location: In the middle of Minnesota!
Posts: 5,804
Received 99 Likes
on
88 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
If you can wait for a few days for shipping, I generally buy my genuine Mopar parts from moparpartsonline. In fact, I just purchased a crank sensor for my 99 XJ for about $50; quite a bit cheaper than most dealerships.
https://www.moparonlineparts.com/
https://www.moparonlineparts.com/
Trending Topics
#8
CF Veteran
Join Date: Nov 2011
Location: phoenix az
Posts: 1,290
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0l 6 cylinder
Originally Posted by F1Addict
I will triple the vote for CPS (Crank Position Sensor) and will reiterate tj's recommendation that you avoid the Chinese made Duralast CPS available at Awful Zone. I know there's a fairly reliable testing procedure for RENIX era CPSs but I'm not sure about later models.
For the record, my agreement with tj regarding imported CPSs is based solely on what I've read, not personal experience. I installed a Duralast in mine a few months ago and have had ZERO problems with it, so far. I think it was $28, which is between 1/2 and 1/4 of what I've seen paid for an OEM unit. I've heard of the Duralasts failing out of the box, though so I probably just got lucky and since they're kind of a pain to replace, it's best to only have to do it once.
For the record, my agreement with tj regarding imported CPSs is based solely on what I've read, not personal experience. I installed a Duralast in mine a few months ago and have had ZERO problems with it, so far. I think it was $28, which is between 1/2 and 1/4 of what I've seen paid for an OEM unit. I've heard of the Duralasts failing out of the box, though so I probably just got lucky and since they're kind of a pain to replace, it's best to only have to do it once.
#10
Newbie
Thread Starter
Join Date: Oct 2010
Location: Jasper, IN
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0L
it was the CPS. had my dad's friend help me out with it and now she's running like a champ again. thanks for the help
Thread
Thread Starter
Forum
Replies
Last Post
jeepnewbie44312
Cherokee Chat
24
01-04-2023 06:05 AM
jmarzo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
10-18-2022 04:11 PM
Dannymac1216
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
09-08-2015 06:28 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)