Correct brake caliper bolts?
#1
Junior Member
Thread Starter
Join Date: Apr 2009
Location: Ames, Iowa
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L
Correct brake caliper bolts?
Yesterday when I had the front axles out to change the u-joints, I noticed my brake caliper bolts were regular 13mm bolts. The write-up on here mentioned allen head bolts.
I noticed that there were what appeared to be helicoils installed in the hanger.
Is that normal, or did someone have to repair my setup at some point? I had a hard time putting one of the four bolts back in and though it's tight, I dont' see it holding up for many more in/out trips.
I noticed that there were what appeared to be helicoils installed in the hanger.
Is that normal, or did someone have to repair my setup at some point? I had a hard time putting one of the four bolts back in and though it's tight, I dont' see it holding up for many more in/out trips.
#3
Member
Join Date: May 2009
Location: Boise, Idaho
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0
make sure youre removing the caliper bolt int he little rubber grommet and not the brake caliper housing bolts.. I beleive those are 13mm and loc tighted in.. they would be HARD to get out and shouldnt need to be taken off. The brake caliper bolt should be very long and different looking .. not your standard bolt.
#4
Junior Member
Thread Starter
Join Date: Apr 2009
Location: Ames, Iowa
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L
Yeah, those were the ones I removed (the ones with the rubber adjustible bellows.) I had both calipers off for yesterday's fun and exciting ujoint exchange.
#5
CF Veteran
Join Date: Apr 2008
Location: Northern Illinois
Posts: 2,237
Likes: 0
Received 3 Likes
on
3 Posts
Year: 90
Model: Cherokee
Engine: 4.0
It depends on the year of the Jeep....
The axle shown in the U-joint write-up is from an 89.. so it still has the 7mm allen head bolts. But newer models thankfully got 13mm regular hex heads on their bolts.
The axle shown in the U-joint write-up is from an 89.. so it still has the 7mm allen head bolts. But newer models thankfully got 13mm regular hex heads on their bolts.
Thread
Thread Starter
Forum
Replies
Last Post
John T
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
02-19-2022 11:27 AM
RickJames Bish
Modified XJ Cherokee Tech
5
09-02-2015 03:22 PM
Montana5991
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-02-2015 09:23 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)