[WTB] Wtb bored throttle body
#5
Junior Member
Thread Starter
Join Date: Nov 2013
Location: Vermont
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0
Ah I see. I was wrong too, I guess xjs are only 60mm on the manifold? Are there any other things done the tbs like proper cleaning and all? Am I able to simple swap my sensors and install?
#6
CF Veteran
Join Date: Nov 2008
Location: Stokesdale, NC
Posts: 1,350
Likes: 0
Received 5 Likes
on
4 Posts
Year: 89XJ,98ZJ,72K10, 06 Tundra..
Model: Cherokee
Engine: 4.0
My TBs..
Check out my ad under the Misc. section.
I bore them, glass bead them, clean them, grease them, and assemble.
I believe the manifold is a little bigger than 60mm, havent measured one.
I do have a 62mm I did...but you would have to make your own throttle plate.
I bore them, glass bead them, clean them, grease them, and assemble.
I believe the manifold is a little bigger than 60mm, havent measured one.
I do have a 62mm I did...but you would have to make your own throttle plate.
Trending Topics
#10
CF Veteran
Join Date: Nov 2008
Location: Stokesdale, NC
Posts: 1,350
Likes: 0
Received 5 Likes
on
4 Posts
Year: 89XJ,98ZJ,72K10, 06 Tundra..
Model: Cherokee
Engine: 4.0
There is nothing to change. Its a stock TB bored out to allow more air flow. I include instructions on how to flash the ECU, which takes about 30 seconds.
I accept Paypal.
PM if interested.
I accept Paypal.
PM if interested.
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
02-15-2024 08:09 AM
libengan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
11-06-2015 09:16 AM
zumer715
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
10-03-2015 07:07 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)