Jeep Cherokee Forum - OEM Cherokee Tech http://www.cherokeeforum.com/ en Thu, 17 May 2012 22:47:43 GMT vBulletin 60 http://www.cherokeeforum.com/images/misc/rss.jpg Jeep Cherokee Forum - OEM Cherokee Tech http://www.cherokeeforum.com/ AC compressor bolts http://www.cherokeeforum.com/f2/ac-compressor-bolts-136029/ Thu, 17 May 2012 22:29:06 GMT I lost the bolts for my AC compressor, doesnt anyone know what size pitch etc i would like to buy new ones I lost the bolts for my AC compressor, doesnt anyone know what size pitch etc i would like to buy new ones ]]> OEM Cherokee Tech phoenix901223 http://www.cherokeeforum.com/f2/ac-compressor-bolts-136029/ busted p*** side axle shaft http://www.cherokeeforum.com/f2/busted-p-side-axle-shaft-136026/ Thu, 17 May 2012 21:53:04 GMT So when I replaced U joints in my D30, i accidentally bent the ears of the outer axle shaft on the right side. I put the new u joint in, but only 3... So when I replaced U joints in my D30, i accidentally bent the ears of the outer axle shaft on the right side. I put the new u joint in, but only 3 of the 4 points would go in because of the bent ear thing. Anyways, it's clunking after I did some pretty rough off roading the other day so i figure it's broken for good. Is it ok to just take the whole axle shaft out until I can replace it? I'll just be without 4wd, right?

thanks ]]> OEM Cherokee Tech Jallen9 http://www.cherokeeforum.com/f2/busted-p-side-axle-shaft-136026/ Gauges, gauges, gauges... http://www.cherokeeforum.com/f2/gauges-gauges-gauges-136013/ Thu, 17 May 2012 20:06:04 GMT Alright well ill try to make this short but i want to add 2 aftermarket gauges to my jeep. Water temp and another one that i haven't picked yet. I want the other one to be of oil temp or oil pressure. Which would be a more important gauge to have for monitoring my jeep's status?
Heres the link for the gauge pod: http://www.autoanything.com/gauges/6...0A1809654.aspx
Again for a 94 XJ 2 gauge pod.

The water temp gauge needs a sending unit. So with a little research, it looks like out radiator hose up top is about 1.19 in on the inside diam. According to this: http://www.autozone.com/autozone/par...=2411_0_10495_

So if i bought this: http://www.glowshiftdirect.com/30-mm...ttachment.aspx Would the sending unit fit inside of the upper radiator hose correctly with the supplied clamps?

Thanks in advance,
Will ]]> OEM Cherokee Tech 94XjSport94 http://www.cherokeeforum.com/f2/gauges-gauges-gauges-136013/ spare tire http://www.cherokeeforum.com/f2/spare-tire-136012/ Thu, 17 May 2012 20:01:38 GMT Just got a 2001 Cherokee Sport but the spare tire and jack and all that suff is missing. I'm guessing that it had a sissor jack and a full sized spare. Anyone have thoughts on replacements.:dunno: ]]> OEM Cherokee Tech cattfish420 http://www.cherokeeforum.com/f2/spare-tire-136012/ New Radiator problems http://www.cherokeeforum.com/f2/new-radiator-problems-136008/ Thu, 17 May 2012 19:42:53 GMT I replaced my radiator recently, it was a O'reilly's replacement and my issue is the mec fan shroud wont fit in there, the tab on the bottom is larger then the original so the curve on the shroud wont allow it to drop in. Anyone else have this issue. I broke the original shroud in trying to find a solution so need something new. Getting hotter then I'd like at the lights. Thank you all for the help. ]]> OEM Cherokee Tech Walter http://www.cherokeeforum.com/f2/new-radiator-problems-136008/ dana 30 outer pinion bearing replacment http://www.cherokeeforum.com/f2/dana-30-outer-pinion-bearing-replacment-136004/ Thu, 17 May 2012 19:31:50 GMT first off i couldnt find any info on this exact problem, my outer pinion bearing is bad what all is involved with changing the outer pinion bearing,... first off i couldnt find any info on this exact problem, my outer pinion bearing is bad what all is involved with changing the outer pinion bearing, from the best i can tell you just remove the yoke,seal then the bearing im just not sure how the race is held into place and if the bearing is press fit or slip fit any info would be appreciated ]]> OEM Cherokee Tech outlawtr450 http://www.cherokeeforum.com/f2/dana-30-outer-pinion-bearing-replacment-136004/ Cracking Radiator? http://www.cherokeeforum.com/f2/cracking-radiator-136001/ Thu, 17 May 2012 18:57:10 GMT Anyone else having this problem? It a oem replacement from O'reilly's and i have been through 4 of them and about to put another in. I don't think its me, they are installed correctly. I am ASE certified so im not a dum dum.:icon_cheesygrin: ]]> OEM Cherokee Tech brianrich07 http://www.cherokeeforum.com/f2/cracking-radiator-136001/ A/C - Alternator question http://www.cherokeeforum.com/f2/c-alternator-question-135997/ Thu, 17 May 2012 18:24:31 GMT 91 laredo. When i turn on the a/c the first time and drive off, the alternator screams and the voltmeter drops way off. I turn it off and turn it... 91 laredo. When i turn on the a/c the first time and drive off, the alternator screams and the voltmeter drops way off. I turn it off and turn it back on again and it works fine. The a/c kicks arse btw. Instant cold. Is this an alternator issue? I would ***ume so but it runs at 14 amps forever all the time based on the dashboard gauge. Except for the first time i turn on the a/c. ]]> OEM Cherokee Tech realmortician http://www.cherokeeforum.com/f2/c-alternator-question-135997/ No rear sway bar http://www.cherokeeforum.com/f2/no-rear-sway-bar-135995/ Thu, 17 May 2012 17:58:10 GMT Hey guys just a quick question. I was fixing a leak in my back diff and noticed that I didn't have a rear sway bar. Is this common or should I question it? I know I don't really need one but I'd just like to know. ]]> OEM Cherokee Tech http://www.cherokeeforum.com/f2/no-rear-sway-bar-135995/ Stumble http://www.cherokeeforum.com/f2/stumble-135988/ Thu, 17 May 2012 16:35:51 GMT Hey guys my 99 has had this problem for awhile now. The issue is when i go to take off. The jeep starts fine and drives down my driveway fine, but... Hey guys my 99 has had this problem for awhile now. The issue is when i go to take off. The jeep starts fine and drives down my driveway fine, but when I get on the road and try to take off it wants to fall on its face, then I hear a pop and she runs great. It does it randomly, and the temperature of the jeep doesnt matter. It will do it cold or hot, but its just so random. Any ideas? ]]> OEM Cherokee Tech 94xjse99xjsport http://www.cherokeeforum.com/f2/stumble-135988/ main cpu http://www.cherokeeforum.com/f2/main-cpu-135982/ Thu, 17 May 2012 16:09:05 GMT 94 XJ, 4.0, auto trans. while driving my jeep died. got it towed back to my house. i have no fuel and no spark. looking for trouble codes, but my... 94 XJ, 4.0, auto trans.
while driving my jeep died. got it towed back to my house. i have no fuel and no spark. looking for trouble codes, but my check engine light just stays on. i have tried cycling the a/c, and shifting through the gears as was suggested by another thread. my gut instinct tells me that my computer is shot. now here is the brilliant part- my battery recently died, and i put a deep cycle rv battery in there to get by for a couple days. did i fry something somehow? input appreciated. ]]> OEM Cherokee Tech Casketneck http://www.cherokeeforum.com/f2/main-cpu-135982/ Is this fixable? http://www.cherokeeforum.com/f2/fixable-135977/ Thu, 17 May 2012 15:33:07 GMT I want to add a lift to my jeep but want to fix the rust issues first, this is the worst of them all, there are about 3 other spots that are small... I want to add a lift to my jeep but want to fix the rust issues first, this is the worst of them all, there are about 3 other spots that are small and can easily be patched
Attached Images
File Type: jpg WP_000521.jpg (92.9 KB)
File Type: jpg WP_000522.jpg (95.6 KB)
]]> OEM Cherokee Tech unidentifiedbomb http://www.cherokeeforum.com/f2/fixable-135977/ Wheel Hub Replacement http://www.cherokeeforum.com/f2/wheel-hub-replacement-135974/ Thu, 17 May 2012 15:08:14 GMT One (or more) of my bearings have starting to growl a bit after about 30mph, so I figure it's probably time to go ahead and replace the front hubs (since as far as I'm aware, you can't just replace the bearing).

How difficult is it to do? Are there any common problems I might run into? Does everything usually come apart fairly easy, or am I going to need a torch and air tools? ]]> OEM Cherokee Tech 77olds http://www.cherokeeforum.com/f2/wheel-hub-replacement-135974/ axle ? http://www.cherokeeforum.com/f2/axle-135969/ Thu, 17 May 2012 13:38:25 GMT hey guys :] ok so im puttin in 4wd. i was tearing down my axle, gettin it ready to install, and i happened to notice tht when i turn my driveshaft (the part it connects to on the pumpkin, dont kno the name.. )only the driver side turns. the p***enger side will turn by hand but not when i turn the driveshaft. is this a problem or is tht jus how it works? thanks for sheading any light! ]]> OEM Cherokee Tech DonnaxSam http://www.cherokeeforum.com/f2/axle-135969/ 1995 Cherokee hitch fit a 2000? http://www.cherokeeforum.com/f2/1995-cherokee-hitch-fit-2000-a-135968/ Thu, 17 May 2012 13:37:08 GMT Hey guys, I have a guy offering to sell me a cl*** 3 hitch that came off his 1995 Cherokee, I was wondering if it fits a 2000 Cherokee or not? Thanks! Hey guys, I have a guy offering to sell me a cl*** 3 hitch that came off his 1995 Cherokee, I was wondering if it fits a 2000 Cherokee or not? Thanks! ]]> OEM Cherokee Tech wifin http://www.cherokeeforum.com/f2/1995-cherokee-hitch-fit-2000-a-135968/